TABLE OF CONTENTS

• Introduction
• Required Equipment
• Instructions
• Diagrams

Introduction

To use Qendercore with your inverter, a Qendercore Hub needs to be installed to the inverter in question. The steps below outline this procedure for the Soltaro AIO2 inverter.

See Qendercore Setup Manual for the most up to date version of any Qendercore Setup Procedures. This document is intended as a short outline of one of the most common parts of the overall Setup process. 

Required Equipment

• DONSTR001 - Qendercore Hub
• Connected to a compatible inverter 

Instructions

WARNING - Ensure the Inverter is powered OFF before beginning. 

1. If present, remove the Center Cover from your AIO2 system by grasping both sides and pulling it towards you.
   
2. Connect the Qendercore hub to your Soltaro All in One 2 by aligning the round connector with the “EMS” connector on the inverter and pushing it upwards
   
3. Once connected, tighten the outer lockring by hand until it is firm.
4. Switch on the inverter and wait for the status LEDs (Green and Yellow) to start flashing.

Diagrams

DONSTR001 - Qendercore Hub