Introduction

To use Qendercore with DIN mounted equipment like a smart meter, a Qendercore DIN Hub needs to be installed in the switchboard and connected to the applicable equipment. The steps below outline this procedure. Instructions for connecting equipment to the DIN Hub can be found at the bottom of the page

See Qendercore Setup Manual for the most up to date version of any Qendercore Setup Procedures. This document is intended as a short outline of one of the most common parts of the overall Setup process. 

Required Equipment

• DONSTR003 - Qendercore DINHub
• Connected to a compatible device
  • METSTR001 - LITIOT Single Phase Smart Meter 

Installation Instructions - DIN Hub

WARNING - Ensure the power is OFF before commencing. Wiring should be done by a licensed electrician in accordance with local regulations

1. Install the DIN Hub onto a standard DIN Rail mount.
   
2. Connect the DIN Hub to 230VAC using the marked terminals on the bottom.
   
3. Switch on the DIN Hub and wait for the status LEDs (Green and Yellow) to start flashing.

You can now connect the DIN Hub to the internet using WiFi (AP) or WPS. To connect the DIN Hub to compatible equipment, please check the instructions below for the relevant equipment. 

Installation Instructions - LITIOT Single Phase Meter (Qendercore Solar Optimiser Setup)

WARNING - Ensure the power is OFF before commencing. Wiring should be done by a licensed electrician in accordance with local regulations

1. Install the LITIOT Meter onto the DIN Rail, next to the Qendercore DIN Hub
2. Connect the LITIOT Meter to 230VAC using Terminal 1 and 3 at the top and bottom. 
3. Connect A and B of the Qendercore DIN Hub to Terminal 5 and 6 of the LITIOT Meter. 
4. Switch the power on to the LITIOT Meter and Qendercore DIN Hub 

Wiring Diagram for Qendercore Solar Optimiser

Diagrams

DONSTR002 - Qendercore Mini Hub

METSTR001 - LITIOT Single Phase Smart Meter