TABLE OF CONTENTS

• Introduction
• Required Equipment
• Instructions
  • Finding Hub ID
  • Linking Hub ID
• Diagrams

Introduction

Once your Qendercore Hub is connected to the internet and communicating with the Qendercore servers, you will need to link the device/s to your account. This document will run you through this procedure using the Hub ID of the Qendercore Device. On some devices, the Hub ID may be physically printed on the device, but it can be accessed via a smart device if it is not. Please make sure that you have connected the Qendercore device to the internet using either Ethernet, WiFi or WPS. 

See Qendercore Setup Manual for the most up to date version of any Qendercore Setup Procedures. This document is intended as a short outline of one of the most common parts of the overall Setup process. 

Required Equipment

• DONSTR001 - Qendercore Inverter Hub OR
• DONSTR002 - Qendercore Mini Hub
• DONSTR003 - Qendercore DIN Hub
• Connected to a compatible device:
  • Soltaro Inverter
  • Soltaro Air Conditioner
  • LITIOT Smart Meter

Instructions

Finding Hub ID

The Hub ID may be printed on your Qendercore Hub, and will start with "Q". If the ID is not visible, you are able to follow the below steps to find it via any smart device. 

1. On your Qendercore Device, double click the Interactive Button to put it into Setup Mode. This will be indicated by the GREEN MODE LED starting to slow flash. 
   1. DONSTR001- Button is located just above the POWER LED. 
   2. DONSTR002- Button is located in the centre of the hub. 
2. Once in Setup Mode, triple click the Interactive Button to activate the Qendercore WiFi AP. This will be indicated by the GREEN MODE LED starting to fast flash. 
3. On your computer or smart device, open your WiFi settings and connect to the WiFi network named "Qendercore". When prompted for a password, input "p1234567". You should be connected to the Qendercore AP, with No Internet.
   
   1. On smart devices with mobile data, it is recommended to switch off mobile data from this point onwards. Airplane mode may be suitable for this. 
4. Once connected, use your preferred Web Browser (Chrome, Edge, Safari, etc), and navigate to http://qendercore.local OR 192.168.89.89. You will be directed to the page below:
   
5. If the Qendercore device is connected to the internet, the QID will be visible in the top right of this page.
   

Linking Hub ID

1. Navigate to the Qendercore Web Page, or download and open the Qendercore App (Android) (Apple)
2. Tap on the Account button in the top right.
   
3. Tap on Link Qore...
   
   1. On the App, this will open the QR Code Reader. You are still able to manually input the QID of the device below the QR reader.
      
   2. In a Web Browser, this will allow you to link the Qendercore device by inputting the unique QID of the device.
      
4. This will prompt you to either "Take Ownership" or "Request Access". Ownership should be taken by the End User of the device, who will then be able to approve any subsequent requests for access (ie. from installers, VPP program's, other house members).

Diagrams

DONSTR001 - Qendercore Hub

DONSTR002 - Qendercore Mini Hub

DONSTR003 - Qendercore DIN Hub