TABLE OF CONTENTS

• Introduction
• Instructions
• Diagrams

Introduction

To use Qendercore with your Air Conditioner, a Qendercore Mini Hub needs to be installed to the Air Conditioner in question. The steps below outline this procedure for the Soltaro Air Conditioner.

See Qendercore Setup Manual for the most up to date version of any Qendercore Setup Procedures. This document is intended as a short outline of one of the most common parts of the overall Setup process. 

Required Equipment

• DONSTR002 - Qendercore Mini Hub
• Connected to a compatible Air Conditioner 

Instructions

WARNING - Ensure the Air Conditioner is powered OFF before beginning. 

1. Lift the Front Cover of the Air Conditioner to access the internals. 
2. Remove the plastic cover on the right hand side that is covering the AC connections
3. Connect the Qendercore hub to your Soltaro Air Conditioner by connecting the included adaptor cable into the compatible plug. If present, remove any other devices connected to this plug.  
   
4. Insert the Mini Hub into the indicated location, and screw it in with the screw. Route the cabling through the correct cable track, and replace the plastic cover over the AC terminals.
   
5. Switch on the Air Conditioner and wait for the status LEDs (Green and Yellow) to start flashing.

You can now connect the Mini Hub to the internet using WiFi (AP) or WPS

Diagrams

DONSTR002 - Qendercore Mini Hub